Minec 4x Manuel d'utilisateur télécharger pdf (Page 15)

Minec 4x User Handbook

5. Battery Functionality

The Minec 4x is powered by one rechargeable Li-ION battery.

Battery Recharging

How often the battery has to be recharged depends on the application. It is a

good habit to connect the Minec 4x to a charger every night. The provided

charger will recharge an empty battery in 3 hours.

From the application program you can control the red LED, located under the

display. While recharging the battery the red diode will shine with a steady

light. When the battery is fully charged the LED flashes slowly (0.5 second

on, 3.5 seconds off). Normally the LED does not need to be observed, but it

can help if a problem is suspected.

At the bottom of the display an indicator is shown

that presents the battery status. If the battery

indicator is all black, the battery is fully charged

and if the indicator is e.g. only filled to 25 %, the

battery has a quarter of its power left.

If you do not recharge the battery it will finally be

impossible to switch on the terminal. However, a

back-up of the collected data is saved

continuously to the Flash disk. Then recharge the

battery and upload the collected data from the

Flash disk before using the Minec 4x as usual.

You may use the terminal while recharging the

batteries. However, you need to recharge the

batteries for at least 15 minutes before using the

mobile phone function while recharging.

CAUTION !

RISK OF EXPLOSION IF BATTERY IS REPLACED

BY AN INCORRECT TYPE.

DISPOSE OF BATTERIES ACCORDING TO THE

BATTERY MANUFACTURER´S INSTRUCTIONS.

Battery

Reset button

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Minec 4x Manuel d'utilisateur Page 15